Page 117 - English_F5

English

IKEA MYRVARV

IMPORTANT SAFETY INSTRUCTIONS
FOR ONLINE READING ONLY
For indoor use only
Regularly, check the cords, the transformer and all other parts for damage. If any part is damaged, the
product should not be used. Important information! Keep these instructions for future use.
CAUTION!

The light source of this product is non-changeable light diodes (LED).
Do not disassemble the product, as the light diode can cause damage to the eyes.
Do not immerse in water.

Cleaning
Use a damp cloth, never a strong cleaning reagent.

CAUTION
To reduce the risk of fire, electric shock or injury to persons: use only insulated staples or
plastic ties to secure cords. Route and secure cords so that they will not be pinched or damaged
when the cabinet is pushed to the wall. Position the portable cabinet light with respect to the
cabinet so that the lamp replacement marking can be read during relamping. Not intended
for recessed installation in ceilings or soffits. The low-voltage portable cabinet light may be
installed inside or under a kitchen cabinet or other built-in furniture when: 1. The low voltage
Class 2 power supply is located outside the cabinet and is not concealed; and 2. The line
voltage power supply cord is not concealed or run through openings in the cabinet, walls,
ceilings or floors. This requirement does not apply to the wiring between the cabinet light
and the power unit. The National Electric Code (NEC) does not permit cords to be concealed
where damage to insulation may go unnoticed. To prevent fire danger, do not run cord behind
the walls, ceilings, soffits or cabinets where it may be inaccessible for examination. Cords
should be visually examined periodically and immediately replaced when any damage is
noted. 3. Injury to persons and damage to the lamp and/ or the mounting to the surface may
result if the lamp is pulled from the surface. To reduce the likelihood of such injury or damage,
mount only on a mechanically sound surface. 4. Use only IKEA LED drivers suited for this
product. The total wattage of the lamp Connected to one LED driver must not exceed the
maximum power stated on that LED driver and never more than 30W.

WARNING
Deviation from the assembly instructions may result in a risk of fire or electric shock.

Source: https://manuals.plus/ikea/myrvarv-manual#ixzz8VNOE7YQH

Form Five 108 Tanzania Institute of Education (TIE)

24/06/2024 22:26
ENGLISH FORM 5.indd 108 24/06/2024 22:26
ENGLISH FORM 5.indd 108