Page 111 - Textile_and_Garment_Form3

Textiles and Garment Construction

(iv) Match notches and baste.
(v) Match facing edges at the seam
CB fold CF
allowance.
sideways view of paper sideways view (vi) Stitch the seam and turn to 5 mm.
back of bodice of front of bodice Press open to reduce bulk.

Procedure for attaching on shaped
(ii) Trace the neck edges, shoulder facings
seams, and armhole. After tracing,
remove the bodice. On the traced (i) Cut out the facing according to the
paper, indicate the required depth pattern. Make sure you pay attention
of the facing plus 1.3cm turnings to all the notches and markings,
and mark the shape with a pencil. as accuracy is very important.

CB CF
Back facing Back facing

Paper

(iii) Add 1.3 to the seam line of the
shoulder if the shoulder of the
garment has been joined. Cut the
facing pattern and trace it on the Front facing
piece of fabric, cut it ready for sewing. Note: If the fabric is thin, cut out
matching fusible interfacing and iron it
CB fold CF onto the wrong side of each facing piece.

(ii) Stitch the shoulders seam of the
facing.

Preparing facing: Do the following for
successfully preparation of the facing.
(i) Stay stitch inside curved edges.

(ii) Treat facing with interfacing.
(iii) Finish the outer edge, i.e, the free
edge of the facing, by overcasting or (iii) Trim the seam edge and press
overlocking. them open ready to match with the
neckline.

102
Student’s Book Form Three

2022/11/17 16:15:03
BOOK TEXTILE FINAL 13.09.2022 FINAL.indd 102 2022/11/17 16:15:03
BOOK TEXTILE FINAL 13.09.2022 FINAL.indd 102